Lumenlab: ProView PL516s - Lumenlab

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

ProView PL516s 15" LCD Monitor

#1 User is offline   captainjack115 

  • Lab Rat
  • Pip
  • Group: Customer
  • Posts: 1
  • Joined: 03-February 05

Posted 21 February 2005 - 09:04 PM

Hi Everyone,

I just bought a Proview PL516s from Circuit City on an "Open Box" sale.
I had the guy hook it up to a computer to make sure it worked ok before I bought it, and it does.
I haven't tried stripping it yet, I was hoping that someone on this forum has done one of these already. Any help?

Captainjack115
0

#2 User is offline   ztodaro 

  • Still Here
  • PipPipPip
  • Group: Customer
  • Posts: 33
  • Joined: 23-May 05

Posted 25 June 2005 - 01:21 AM

captainjack115, on Feb 21 2005, 02:04 PM, said:

Hi Everyone,

I just bought a Proview PL516s from Circuit City on an "Open Box" sale.
I had the guy hook it up to a computer to make sure it worked ok before I bought it, and it does.
I haven't tried stripping it yet, I was hoping that someone on this forum has done one of these already.  Any help?

Captainjack115
<{POST_SNAPBACK}>


I bought a 516, I found it fairly difficult to strip, lots of very small screws that became stripped out easily. Two FFC's, one small that connected from the side, And one that came from the top, that had a 90 degree angle, which allowed the control board to be swung to the side. I believe an extension would solve the problem of having the ffc in the way of the projection. I fried my control board trying to set up a ground, so now its time to strip my new 520D.
0
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users